Back to top

Extinguisher head caps deserve closer inspection - Mon 31st Mar 2014

Extinguisher head caps deserve closer inspection

Constant vigilance is needed when protecting your property from fire - and that means checking all safety equipment is in full working order.

One of the issues which is easy to overlook in this busy world is the maintenance of fire-fighting equipment, particularly extinguishers. It's not enough just to ensure you have adequate supplies for any emergency, you need to keep an eye on the condition of them, too.

At Fire Security Services, we've noticed an increase in the number of fire extinguishers with plastic heads affected by UV degradation. This is potentially a very serious hazard and it's another thing you need to be looking out for.

Like many products we buy in our day-to-day lives, there are different types and quality of fire extinguisher on the market and, similarly, their shelf life and safety vary tremendously. Some are easier to damage, because they are made from inferior material, some rust quicker, some have so many intricate parts they are not cost-effective to service repeatedly.

But, perhaps most critically, some extinguishers now on the market have plastic heads which will need replacing after five years because the material degrades in sunlight. These caps can be difficult and expensive to find and it is often easier and cheaper to replace the whole extinguisher.

To check whether your extinguishers are safe, check the head cap. Is it going white, or changing colour? If so, don't touch it – it could be dangerous. Call us and we'll come to see what needs to be done.

The Fire Industry Association has put out the following suggestions over servicing of extinguishers, highlighting new guidelines brought in from 2010. Plastic head caps should be replaced on the following grounds:

  • At basic service, only if there are obvious signs of UV degradation or if the head cap has been over-painted, which is usually an indication that there has been an attempt to conceal UV degradation.
  • At extended service, either before the discharge test if there is concern over UV degradation, or before reassembly if there are no concerns.

The association recommends the following procedures are adopted:

  • For stored pressure extinguishers (excluding CO2 extinguishers), the discharge test should be carried out, after which the head cap should be removed and replaced with a new head cap.
  • With gas cartridge extinguishers, the head cap should be removed before discharge testing and destroyed. A new head cap will then need to be fitted and the discharge test then carried out. In addition, the requirements of the standard this will “confirm that the extinguisher operates and the head cap is compatible and has been fitted corrected.

For further information on courses, dates and prices, please contact us.

Back